Transparent Lens Assemblies and Reflector Components

The sample photographs show transparent lenses and circular reflector-like components in several arrangements. The parts illustrate the need to consider the moulded lens and its mating housing or reflector as an assembly.

Features to review before tooling

Review the edge geometry, locating features, visible surfaces and the relationship between mating pieces. The material, colour and finish should be established from the actual design instead of being inferred from a photograph.

Tooling and sample review

Tooling decisions can then address gates, parting lines, release and the finish on critical faces. Sample checks may cover fit, cosmetic defects and application-specific optical measurements defined by the customer.

Starting a similar project

Share your current 2D or 3D drawings, material and finish requirements, expected quantities and the dimensions or functions that matter most. The tooling route, sample checks and supply plan can then be discussed for your part.

Contact JingZhan or email yw07@jz-mould.com to begin a project review.